OpenBCI Setup

In order to make the EMG input work well, you need to plug the Bluetooth dongle in your pc, turn the Cyton board on by putting it in PC mode.

Once this is done, open OpenBCI GUI. Click on CYTON (live) and then click on manual and check if you have the port like in the screenshot :

If this is well done, you just have to click on start session, et voilà !

Now, modify the disposition of your layout, by changing the bottom-right panel to Networking, and put as a datatype EMG as such :

Then, start the UDP stream and start the data stream (at the top-left corner of the tab) !