drm/dp: Change AUX DPCD probe address from DPCD_REV to LANE0_1_STATUS

Reading DPCD registers has side-effects in general. In particular
accessing registers outside of the link training register range
(0x102-0x106, 0x202-0x207, 0x200c-0x200f, 0x2216) is explicitly
forbidden by the DP v2.1 Standard, see

3.6.5.1 DPTX AUX Transaction Handling Mandates
3.6.7.4 128b/132b DP Link Layer LTTPR Link Training Mandates

Based on my tests, accessing the DPCD_REV register during the link
training of an UHBR TBT DP tunnel sink leads to link training failures.

Solve the above by using the DP_LANE0_1_STATUS (0x202) register for the
DPCD register access quirk.

Cc: <[email protected]>
Cc: Ville Syrjälä <[email protected]>
Cc: Jani Nikula <[email protected]>
Acked-by: Jani Nikula <[email protected]>
Signed-off-by: Imre Deak <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
(cherry picked from commit a40c5d7)
Signed-off-by: Joonas Lahtinen <[email protected]>

Author: ideak

drivers/gpu/drm/display/drm_dp_helper.c

@@ -725,7 +725,7 @@ ssize_t drm_dp_dpcd_read(struct drm_dp_aux *aux, unsigned int offset,
 	 * monitor doesn't power down exactly after the throw away read.
 	 */
 	if (!aux->is_remote) {
-		ret = drm_dp_dpcd_probe(aux, DP_DPCD_REV);
+		ret = drm_dp_dpcd_probe(aux, DP_LANE0_1_STATUS);
 		if (ret < 0)
 			return ret;
 	}