Stock fan shroud

[bakaneko718]

There is a file of a bracket for the stock fan shroud on the ender 3 pro, but it doesnt account for the direct drive set up nor does there seem to be a clear way to attach it to the tool plate. I am using the direct drive set up that I had purchased from your store.

[Next-victim]

I straight up mounted my MDD carage plate to the Xchange to get mine going. Not great, but doesnt seem to interfere with anything. Here's a phone from the mounting test, before rewirin

I don't know what else to call it but pure jank. Only the 2 hotend screws and the SINGLE screw to the right of them actually line up, so I back fead the one that wasnt part of the hotend. Then used a small screw as a guide for the left one and got the right screw passed througth the hot end and both plates. From there, I got the left hot end screw in by fiddling with it and not removing the far right "alignment" screw. I then proceeded to remove the alignment screw and back feed it with a small screw that wouldnt hit the hot end or interfere with the XChange setup.

My off sets are screwed but it will let me print a front plate brackate with opening for the Ender 3 fan assembly. This is on an Ender 5 but the idea is the same for the 3 and 5, just a narrower bracket on the 3.
g.