Issues on a fresh install of 20.04

[zhangzhihao2020]

when I install openrave in ubuntu2020,I miss this mistake and don't find the way to solve it.
<<
CMake Error at python/bindings/CMakeLists.txt:50 (message):
Should have installed pybind11; CMake will exit.
-- Configuring incomplete, errors occurred!
See also "/home/zzh/git/openrave/build/CMakeFiles/CMakeOutput.log".
See also "/home/zzh/git/openrave/build/CMakeFiles/CMakeError.log".
make: *** No targets specified and no makefile found. Stop.
make: *** No rule to make target 'install'. Stop.
<<
If anyone knows the solution,please tell me,thank you!

[thoreauA]

Hi! I am trying to use openrave as well in Ubuntu 20.04 and it seems not an easy task. In your case you had not properly installed pybind11.
Look to the file install-dependencies.sh at # Install Pybind, make sure that all the lines are executed and that pybind11 is successfully installed.

[nicholasadr]

Most likely pybind11 installation was skipped in ./install-dependencies.sh due to problem 2 mentioned in #19 (Look for "Please tell me who you are" printout). In that case you need to perform Git authentication beforehand:

git config --global user.email "you@example.com"
git config --global user.name "Your Name"

[bjutlss]

I ran into the same problem, but I think I built pybind11 successfully, and I already have the content in the build folder, but I still have this problem at the last step.
My Ubuntu is 20.04, python = 3.9. Can you give me a little help？ @nicholasadr

[zichunxx]

Any update on pybind-related problems on Ubuntu 20.04?