I'm trying to flash an 85MB firmware right now, but it's telling me the file is too large. What should I do?

[a1768623020]

Here's the error message from the webpage:

The TTL output is as follows:

U-Boot 2026.07-rc4-00085-ga21accc0d1c9-dirty (Jun 21 2026 - 21:06:48 +0800)

CPU:   Airoha AN7581
DRAM:  2 GiB
Core:  31 devices, 18 uclasses, devicetree: separate
MMC:
Loading Environment from UBI... spi-nand: spi_nand nand@0: Winbond SPI NAND was found.
spi-nand: spi_nand nand@0: 512 MiB, block size: 128 KiB, page size: 2048, OOB size: 128
Read 16384 bytes from volume ubootenv to 00000000ffafcb80
Read 16384 bytes from volume ubootenv2 to 00000000ffb00bc0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
UBI partition 'ubi' already selected
Read 24582 bytes from volume factory to 00000000ffb5a590
Recovery button detected, starting web recovery...
Recovery status LEDs: gpio17(L) gpio19(L) gpio29(L) gpio20(L)
DHCP recovery server: 192.168.255.1/67 -> offer 192.168.255.2 mask 255.255.255.0 gw 192.168.255.1 bcast 192.168.255.255
HTTP recovery server listening on http://192.168.255.1/
httpd: POST headers accepted, content_len=89182486 data_len=430
UBI partition 'ubi' already selected
httpd: content_len 89182486 exceeds allowed max 15491072 (target limit 15491072, ofs 0x0)

[Arthur97172]

Refresh the page, open CMD, and run a continuous ping (ping 192.168.255.1 -t) to ensure connection stability

[YYH2913]

This issue has been fixed in the latest version.