MIPS: mm: tlb-r4k: Uniquify TLB entries on init

commit 35ad7e1 upstream.

Hardware or bootloader will initialize TLB entries to any value, which
may collide with kernel's UNIQUE_ENTRYHI value. On MIPS microAptiv/M5150
family of cores this will trigger machine check exception and cause boot
failure. On M5150 simulation this could happen 7 times out of 1000 boots.

Replace local_flush_tlb_all() with r4k_tlb_uniquify() which probes each
TLB ENTRIHI unique value for collisions before it's written, and in case
of collision try a different ASID.

Cc: [email protected]
Signed-off-by: Jiaxun Yang <[email protected]>
Signed-off-by: Thomas Bogendoerfer <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>

Author: FlyGoat

arch/mips/mm/tlb-r4k.c

@@ -508,6 +508,60 @@ static int __init set_ntlb(char *str)
 
 __setup("ntlb=", set_ntlb);
 
+/* Initialise all TLB entries with unique values */
+static void r4k_tlb_uniquify(void)
+{
+	int entry = num_wired_entries();
+
+	htw_stop();
+	write_c0_entrylo0(0);
+	write_c0_entrylo1(0);
+
+	while (entry < current_cpu_data.tlbsize) {
+		unsigned long asid_mask = cpu_asid_mask(&current_cpu_data);
+		unsigned long asid = 0;
+		int idx;
+
+		/* Skip wired MMID to make ginvt_mmid work */
+		if (cpu_has_mmid)
+			asid = MMID_KERNEL_WIRED + 1;
+
+		/* Check for match before using UNIQUE_ENTRYHI */
+		do {
+			if (cpu_has_mmid) {
+				write_c0_memorymapid(asid);
+				write_c0_entryhi(UNIQUE_ENTRYHI(entry));
+			} else {
+				write_c0_entryhi(UNIQUE_ENTRYHI(entry) | asid);
+			}
+			mtc0_tlbw_hazard();
+			tlb_probe();
+			tlb_probe_hazard();
+			idx = read_c0_index();
+			/* No match or match is on current entry */
+			if (idx < 0 || idx == entry)
+				break;
+			/*
+			 * If we hit a match, we need to try again with
+			 * a different ASID.
+			 */
+			asid++;
+		} while (asid < asid_mask);
+
+		if (idx >= 0 && idx != entry)
+			panic("Unable to uniquify TLB entry %d", idx);
+
+		write_c0_index(entry);
+		mtc0_tlbw_hazard();
+		tlb_write_indexed();
+		entry++;
+	}
+
+	tlbw_use_hazard();
+	htw_start();
+	flush_micro_tlb();
+}
+
 /*
  * Configure TLB (for init or after a CPU has been powered off).
  */
@@ -547,7 +601,7 @@ static void r4k_tlb_configure(void)
 	temp_tlb_entry = current_cpu_data.tlbsize - 1;
 
 	/* From this point on the ARC firmware is dead.	 */
-	local_flush_tlb_all();
+	r4k_tlb_uniquify();
 
 	/* Did I tell you that ARC SUCKS?  */
 }