KVM: arm64: Fix error checking for FFA_VERSION

According to section 13.2 of the DEN0077 FF-A specification, when
firmware does not support the requested version, it should reply with
FFA_RET_NOT_SUPPORTED(-1). Table 13.6 specifies the type of the error
code as int32.
Currently, the error checking logic compares the unsigned long return
value it got from the SMC layer, against a "-1" literal. This fails due
to a type mismatch: the literal is extended to 64 bits, whereas the
register contains only 32 bits of ones(0x00000000ffffffff).
Consequently, hyp_ffa_init misinterprets the "-1" return value as an
invalid FF-A version. This prevents pKVM initialization on devices where
FF-A is not supported in firmware.
Fix this by explicitly casting res.a0 to s32.

Signed-off-by: Kornel Dulęba <[email protected]>
Acked-by: Will Deacon <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Marc Zyngier <[email protected]>

Author: kornelduleba

arch/arm64/kvm/hyp/nvhe/ffa.c

@@ -792,7 +792,7 @@ static void do_ffa_version(struct arm_smccc_1_2_regs *res,
 			.a0 = FFA_VERSION,
 			.a1 = ffa_req_version,
 		}, res);
-		if (res->a0 == FFA_RET_NOT_SUPPORTED)
+		if ((s32)res->a0 == FFA_RET_NOT_SUPPORTED)
 			goto unlock;
 
 		hyp_ffa_version = ffa_req_version;
@@ -943,7 +943,7 @@ int hyp_ffa_init(void *pages)
 		.a0 = FFA_VERSION,
 		.a1 = FFA_VERSION_1_2,
 	}, &res);
-	if (res.a0 == FFA_RET_NOT_SUPPORTED)
+	if ((s32)res.a0 == FFA_RET_NOT_SUPPORTED)
 		return 0;
 
 	/*