scsi: fnic: Replace return codes in fnic_clean_pending_aborts()

fnic_clean_pending_aborts() was returning a non-zero value irrespective of
failure or success.  This caused the caller of this function to assume that
the device reset had failed, even though it would succeed in most cases. As
a consequence, a successful device reset would escalate to host reset.

Reviewed-by: Sesidhar Baddela <[email protected]>
Tested-by: Karan Tilak Kumar <[email protected]>
Signed-off-by: Karan Tilak Kumar <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Martin K. Petersen <[email protected]>

Author: kartilak

drivers/scsi/fnic/fnic.h

@@ -27,7 +27,7 @@
 
 #define DRV_NAME		"fnic"
 #define DRV_DESCRIPTION		"Cisco FCoE HBA Driver"
-#define DRV_VERSION		"1.6.0.54"
+#define DRV_VERSION		"1.6.0.55"
 #define PFX			DRV_NAME ": "
 #define DFX                     DRV_NAME "%d: "
 

drivers/scsi/fnic/fnic_scsi.c

@@ -2139,7 +2139,7 @@ static int fnic_clean_pending_aborts(struct fnic *fnic,
 				     bool new_sc)
 
 {
-	int ret = SUCCESS;
+	int ret = 0;
 	struct fnic_pending_aborts_iter_data iter_data = {
 		.fnic = fnic,
 		.lun_dev = lr_sc->device,
@@ -2159,9 +2159,11 @@ static int fnic_clean_pending_aborts(struct fnic *fnic,
 
 	/* walk again to check, if IOs are still pending in fw */
 	if (fnic_is_abts_pending(fnic, lr_sc))
-		ret = FAILED;
+		ret = 1;
 
 clean_pending_aborts_end:
+	FNIC_SCSI_DBG(KERN_INFO, fnic->lport->host,
+			"%s: exit status: %d\n", __func__, ret);
 	return ret;
 }